|
Hot Water Household Automatic Boosting Pump
Is your shower pressure very poor or dribble?
Here is your hot water type shower booster.
- Have a high pressure shower at lowest cost.
- Use existing low pressure mixers and fittings.
- Why pay $2500+ for main pressure cylinder & labour?
- Enjoy a decent shower with low pressure cylinder !
Specially designed for hot water Max 110C
Best Solution for Low Pressure Cylinder Shower in NZ
-Boosts pressure when you open tap; stops automatically when tap is closed;
-Pre-wired pump with NZ standard 3-pin plug;
-Fit it between Cylinder Outlet & shower tap;
-Install pump without any change easily;
-Suitable for single and two story house.
Features
The automatic switch adopts electronics theory, controlled by water current. The pump boosts pressure automatically when the tap is on, and turned off when the tap is off. It is used conveniently, and also saves power. Its copper pump body, copper impeller and stainless steel shaft are corrosion-resistant, stainless. The whole pump is sealed well and the conveyed water will be sanitary. Its total suction lift is high. Flow rate is large. It starts well, switches sensitively and automatically, produces low noise. It also is designed to be low temperature, small volume, delicate appearance and long-working time.
Main Use
This pump absolutely solves the lit fire properly of shower owing to the lower pressure and unreliable pressure. When the tap water is of low pressure, the pump can boost pressure.
It can also boost pressure for solar water heaters, boost pressure and circulate water for industrial equipments, and increase Oxygen for rearing ponds and fish tanks. GR hot-water pumps boost pressure and circulate hot water for boilers besides above using. GZ best feature is that it can suck tap water from one or two floor below directly. So it completely solves the problem that the higher floors don't have water while the lower floors have.
Performance Curves
Technical Data
| Model |
Power
(W) |
Voltage
(V) |
Frequency
(Hz) |
Speed
(r/min) |
Input & Outlet Dia.
(mm) |
Highest Head
(m) |
Rated Head
(m) |
Max. Capacity
(L/min) |
Rated Capcity
(L/min) |
G.W.
(kg) |
Q'ty
(pcs) |
PACKAGE DIMENSION
(cm) |
| L |
W |
H |
| WPCL15GR10 |
90 |
230 |
50 |
2860 |
20 |
10 |
6 |
20 |
8 |
26 |
8 |
42.8 |
32 |
27.5 |
| WPCL15GR15 |
120 |
230 |
50 |
2860 |
20 |
15 |
10 |
25 |
10 |
18 |
4 |
30.5 |
24.5 |
32.5 |
Installation Dimensions
Structure Chart
| N. |
Description |
N. |
Description |
N. |
Description |
| 1 |
Fan cover |
7 |
Bolt |
13 |
Rotor |
| 2 |
End-shield |
8 |
Copper Impeller |
14 |
Front-shield |
| 3 |
Ball bearing |
9 |
Automatic switch |
15 |
Copper adaptor |
| 4 |
Stator (Coil winding) |
10 |
Bolt |
16 |
Mechanical seal |
| 5 |
Ball bearing |
11 |
Fan |
17 |
Copper pump casing |
| 6 |
Thermal insulation ring |
12 |
Base bracket |
|
|
Application Draft
|
